Transceiver Interface Module in Mumbai (ट्रांसीवर इंटरफ़ेस मॉड्यूल, मुंबई)

Interfac Modules for Sub-D connectors, Mal Connectors, for mating connectors with solder connection, 289 series

Relay modules are an excellent solution for transmission of electric signals between PLC / DCS system and field actuator / sensor.

Being one of the reputed organizations in the market, we are engaged in manufacturing and supplying an optimum quality Zone Interface Module. Precisely engineered, our provided module provides an ideal solution to the monitoring and control requirements of any system.Further, our offered module is manufactured using quality proven components and advanced technology under the guidance of our skilled personnel. Additionally, it is stringently checked under defined parameters of quality by our quality experts. Features: Reliable performance Work efficient Fully compatible Specifications: Voltage: 24v DC =/- 6 volts. (110/ 240v Optional) Stby Current with EOL: 10 mA. Alarm Current: 80 mA. Max Fault Current: Open Ckt. 25 mA. Short Ckt. 120mA. Detectors 40 conventional Detectors Max. MCP unlimited. EOL Resistor 4700 ohms. Alarm resistance. 470 Ohms. Interface to Monitor Module Normal: 47k EOL built in. Fault: Open Circuit. Fire Alarm: 1000 ohms. LED Indications 5 mm Amber 2 Nos. Detector Circuit Open / short circuit Fault indication. 5 mm Red 1 No for Fire Alarm. Isolation. 1000v min between Detector and Monitor Module Terminals. Dimension Width 120 mm, Height 80 mm, Depth 55 mm. Housing Material: ABS. Protection: IP 67.

SSR Module with I/P

TRENDinterface converts output signals of HOFFRICHTER devices from digital to analogue for the galvanic separated input to established polysomnography systems and enables the communication with PC software TRENDset or remote control TRENDremote.

We offer opto interface module which is used to interconnect devices in the industrial sectors. Specifically it is used to expand traditional terminal block I/O by including the blocks with high density of our opto interface module used in the electronic connectors. These high quality interface module ensures superior durability and is available in standard sizes according to the requirements of our customers.

Interface Module

Interface Modules

Interface Modules

The UIM100C is used to connect 100-series amplifier modules and signal cables to an MP system and is included in all MP Starter Systems.Sixteen analog input channels plus 2 analog output channels are provided via standard 3.5 mm phone jacks on the front panel. The back panel provides access to 16 digital I/O lines and an external trigger input via screw terminals. Amplifier modules snap onto the side of the UIM100C for signal routing to the MP data acquisition unit. The output of any amplifier module snapped to the UIM100C can be monitored, during acquisition, via the corresponding 3.5 mm analog channel phone jack. The UIM100C also provides a direct link to the analog and digital I/O lines of the MP device when collecting or sending data to external equipment. Connecting the UIM100C to the MP System MP150: Snap the UIM100C onto the right side of the MP150.MP100: Connect the UIM100C to the MP100 acquisition unit via two included 0.6-meter cables: o 37-pin connector for analog signals o 25-pin connector for digital signals

Building interface module

Field Interface Module

Interface Modules

Transceiver Interface Module

Interface Modules

Cisco XENPAK Modules