Our organization has gained immense recognition for offering Industrial Process Water Temperature Control System. The offered control system is valued in the market for its performance. This control system is designed by quality material in compliance with set guidelines. Offered control system is tested in terms of quality so as to dispatch a flawless range. Features:
Rigid designHassel free functioningLong service life
We design, develop and engineer world class Motorized Registration
Control for printing machines. To avoid maintain the print
consistency deviation. We machine specially designed Motorized
Registration Control they are ideally used for the registration control
of rotogravure printing machine. To ease the operation, we use gear
boxes fitted in the machine. This ensures our clients with an accuracy
of 25 microns reduces registration wastage to a greater extent.
Apart from this misregistration causes poor print quality and higher
wastage. Our designed Motorised Registration Control System can provide
multiple benefits.
In addition to monitoring the turbine mechanisms, turbine automatic controls provide also the following: Water pumping out of the head cover; Control of oil transfer pump; Air admission when operating in synchronous condenser mode; Air admission under transient operation conditions. The following parameters are automatically controlled: Temperature of turbine bearing shells and oil; Oil level in turbine bearing reservoir; water discharge to oil cooler; Discharge and pressure of water supplied to turbine shaft seal; Water discharge through the turbine; Turbine bearing vibration; Condition of shear pins; Turbine shaft runout; Oil level in oil transfer tank; Power supply control; Position of locking devices; Level of depressed water in synchronous condenser mode; Pressure in maintenance seal. The operation of turbine automatic controls is based on the same principles as the operation of oil pressure system controls. Various sensors convert the values of monitoredparameters of turbine mechanisms into corresponding analog and discrete signals coming in turbine automatic control cubicle (KAI). If any of the monitored parameters is beyond the range of permissible values but the mechanisms still can operate, a warning signal is initiated. When the parameters reach their dangerous values, a command signal for automatic emergency shutdown of the hydro-unit is fed. Turbine automatic control cubicle is similar to oil pressure system control cubicle: logic section forms output signals according to preset law to be applied to the actuating mechanisms of turbine automatic controls.