Grouting Compound

Lokfix P by Fosroc is a high-strength polyester resin-based anchor grout designed for fixing rebar, bolts, and other steel elements in horizontal and overhead positions. It is non-expansive, corrosion-resistant, and offers rapid strength gain, making it ideal for critical anchoring applications. Pack Size: 500 ml (Part A: Base + Part B: Filler) Type: Pourable / Gun Injectable (based on variant) Key Features: Rapid strength development Corrosion and vibration resistant Can be applied overhead Suitable for dry and moist substrates Can be placed underwater Applications: Fixing of starter bars and bolts Horizontal and overhead rebar anchoring Structural strengthening in marine or water-logged areas Fast-track construction repairs

MasterFlow 718 is a ready to use, non-shrink, natural aggregate cementitious grout for use in general civil engineering works. MasterFlow 718 provides extended working life and high early and ultimate strengths.

Hi-Grout 100 is a plasticized expanding grout powder additive which when mixed with cementitious system imparts shrinkage compensation and high flowability. It is a combination of a plasticizing agent use of a reduced W/c ratio with consequent increased strength durability and a gas producing expansion medium counteracts the natural settlement and plastic shrinkage of the grout and aids stability and cohesion. It is suitable for Pre-Stressing grout admixture when complying with BS888110-1:1997-A. USES Cable duct grouting. Bed grouting. Filling and Jointing. Pressure Grouting. Filling up the plumbing and electric chases. Cavity filling. ADVANTAGES Economical to use. Compatible with all types of admixtures and cements. Compensates shrinkage in plastic stage. Reduces W/c ratio, improves strength and pumpability. PACKING Hi Grout 100 is supplied 250gms pouches. PROPERTIES Aspect :Light yellow free flowing powder Chlorideion content :Nil Dosage :250gm/50kg cement Compressive Strength :Its Plasticising action allows the reduction of W/c ratio of grouts whilst maintaining flow properties. This gives improvement in strength and long term durability when cured under restraint Setting Times : It does not affect the setting times. Volume Expansion : up to 4% (Neat cement grout*) : up to 2% (Cement sand grout*) *Properties of mix as suggested in directions for use Compatibility: compatible with all types of Portland cement. APPLICATION All areas to be grouted must be clean and free of oil, grease, dirt and dust. Remove all loose materials. All metal components to be in contact with grout must be free of rust, paint, or oils. All concrete to come in contact with the grout must be thoroughly saturated with clean water for a minimum of 12 hours before placement of grout. Remove excess water from holes and voids just before grout placement. A mechanically powered grout mixer must be used for best results. It is essential that machine mixing capacity and labour availability is adequate to enable the grouting operation to be carried out continuously. This may require the use of a holding tank with provision for gentle agitation to maintain fluidity. First take water in the mixer and then the Portland cement, mix thoroughly until the cement has been completely dispersed. Then add Hi - Grout 100 and sand (if any is being used), and continue mixing a further 5 minutes, making sure that a smooth even consistency is obtained. The grout shall be placed within 15 minutes of mixing to gain the full benefit of the expansion process. Usual placing or pumping procedures shall be adopted ensuring a continuous operation.