Monitor Switcher

2 Pole 2 Way

If you wish to monitor all the cameras in Quad sequence only, by pass all cameras by programming time to 00 sec. Variable time delay of 0-99 sec is possible in the sequence of quad.

Switchers/Controllers/Monitors Switchers - Silent / With audioMatrix SwitchersQuad UnitsAudio Modules

RT 638 - 1 Pole 2 Way 4.5mm Knob RT 644 - 1 Pole 2 Way 6.5mm Knob RT 645 - 1 Pole 2 Way 8.5mm Knob

and diagnostic capability for up to 8 full duplex T1, E1, and J1 lines. The unit provides two RJ-48c connectors for a thru connection for equipment and line connections and a Rj-48c monitor connector for monitoring both directions of a full duplex high speed line. The switch can be remotely controlled via a USB connection. GUI and scripted control software is available for placing the switch in various modes for monitoring and diagnostic purposes.

Multipage Products

Switcher

Switcher Monitoring is a 24/7 remote central monitoring solution designed specifically for GeoVision Surveillance Systems. Powered by a professional monitoring stations with fully BS-8418 compliant and European Monitoring Standards.

If you wish to monitor all the cameras in quad sequence only, by pass all cameras by programming time to 00 sec. Variable time delay of 0-99 sec is possible in the sequence of quad. Sequence is p1, p2, p3, p4.

Switcher is a device which is required when more then one camera are installed, screen to see live picture from camera is less then number of camera s installed. Here, switcher shows output of each camera for few seconds, one by one, on the screen. Nowadays Split Switchers are available, which reduces headache of wiring of each camera up to monitor. Hear we have shown 4X1 Switcher. It s used when there are 4 numbers of cameras and there is only one screen.