Conductivity Controller in Thane (प्रवाहकत्त्व नियंत्रक, ठाणे)

The BL983317 is a compact, panel mounted, process controller for measuring conductivity of a process stream. The device features a large LCD with protective cover. Users may choose from automatic or manual dosing modes. When in automatic mode the dry contact relay is activated when a reading is below the set point. The relay can be used to activate a dosing pump to add chemical until the desired set point is reached. Chemicals that can be dosed include nutrient solutions. The BL983327 is a closely related product that has the same measurement range but has a relay that is activated when the reading is above the set point. Multicolor LED Indicator LED changes color based on status. Fire Retardant Casing For additional safety the controllers outer case is made of fire resistant plastic. Splash Resistant Cover A clear plastic cover protects the face panel from dirt and liquids.

DEWAG make conductivity level controller utilises the electrical current conducting property of the medium whose level is to be detected. Normally two electrodes are installed in a container/tank. One electrode is set at the bottom of the tank and is called a REFERENCE electrode. The other electrode is set at the point where the level is to be detected. When the material touches this electrode, an electrical current flows between these electrodes . This current is sensed and an electronic circuit actuates an electro magnetic relay, which controls the external control devices. This type of level control gives only ON / OFF output. It is possible to have level indication at more than one point. RS-02 Series Level Controller employs three electrodes to indicate levels at two points, viz. REFERENCE ELECTRODE, LOW LEVEL ELECTRODE, and HIGH LEVEL ELECTRODE. It consists of two parts viz. Sensor Unit and Control Unit. Features Tri colored (Green, Yellow Red) LEDs to display Power On, Low Level and High Level status Two changeover potential free relay contacts for each Low and High Levels Control and Sensor Units are housed in an IP65 enclosure Low and High Level detection points are adjustable on site Easy to install. Dimensions Control Unit: 253mm width X 217mm length X 110mm height Sensor Unit: 120mm width X 140mm length X 70mm height Technical Specifications Supply Voltage:- 230V AC, 50 Hz Ordering Information Series: RS-02 Model: 08

Conductivity Controller